Biến tần‎ > ‎

sửa biến tần yaskawa

chuyên sửa chữa biến tần yaskawa , servo Yaskaawa, PLC yaskawa. cung cấp linh kiện biến tần Yaskawa, hỗ trợ kỹ thuật hãng Yaskawa tại HCM và các tỉnh phía nam

Bảng mã lỗi biến tần Yaskawa

boL -  Braking Transistor Overload Fault
bUS -  Option Communication Error
CE   -   MEMOBUS/Modbus Communication
CPF00, CPF01 - Control Circuit Error
CPF02 - A/D Conversion Error
CPF03 - Control Board Connection Error
CPF06 - EEPROM Memory Data Error 
CPF07, CPF08 - Terminal Board Connection Error
CPF20, CPF21 - Control Circuit Error
CPF22 - Hybrid IC Error
CPF23 - Control Board Connection Error
CPF24 - Drive Unit Signal Fault
CPF25 - Terminal Board not Connected
CPF26 to CPF35,
CPF40 to CPF45 - Control Circuit Error
dv7 - Polarity Judge Timeout
EF1 to EF8 - External Fault (input terminal S1 to S8)
FAn - Internal Fan Fault
FbH - Excessive PI Feedback 
UL3 - Undertorque Detection 
FbL - PI Feedback Loss  
UL6 - Motor Underload 
GF - Ground Fault  
UnbC - Current Unbalance
LF - Output Phase Loss 
Uv1 - Undervoltage
Uv2
Uv3
OL1
OL2

Bảng mã lỗi servo Yaskawa

  • Servo yaskawa Sigma2 báo lỗi

- A.02:  SERVOPACK EEPROM data error (Parameter damage)

- A.03: Main circuit detection error

- A.04: Parameter setting error

- A.05: Motor, SERVOPACK capacity mismatch

- A.10: Overcurrent or heatsink overheat

- A.30: Regenerative error (resistor cut off, transistor short failure)

- A.32: Regenerative overload

- A.40: Overvoltage

- A.41: Insufficient voltage

- A.51: Overspeed

- A.71: Overload (Momentary maximum load)

- A.72: Overload (Continuous maximum load)

- A.73: DB Overload

- A.74: Surge resistor overload

- A.7A: Heatsink overheat (Displayed when 30W to 1000W)

- A.81: Encoder backup alarm

- A.82: Encoder SUM check alarm

- A.83: Encoder battery alarm

- A84 Encoder absolute alarm

- A.85: Encoder overspeed

- A.86: Encoder overheat

- A.B1: Speed reference A/D error

- A.B2: Torque reference A/D error

- A.C1: Runaway

- A.C8: Encoder clear error, Multi-turn limit setting error

- A.C9: Encorder communication error

- A.CA: Encoder parameter error

- A.Cb: Encoder echoback error

- A.Do: Excessive position offset

- A.F1: Power line lost phase